How To Make Hat Patches

Besides making your own means you can create any picture or design you please.

How to make hat patches. If it covers it youre good to go. This quick and easy hack will help you make almost any hat into a patch hat. Remove the film covering the adhesive on the back of the raggy patch.

Then take two of the pins and pin the patch to the hat. I did however find a few that had promise but the steps were to many and the process took much longer than expected. Just in case youd like to try your hand at making DIY patches in the custom designs youd like most as well check out these 15 designs ideas guides and tutorials that will help you make it happen.

Place the wrong side of your fabric onto the sticky peel n stick paper. Remove the Heat N Bond backing then apply the patch to the hat. Cut around the stitching leaving 18 inch to 14 inch depending on how much of the edge you want to show.

Remove white sticky paper peel n stick sheet from the packaging. Remove the teflon sheet and cut the canvas to the Printable Heat Transfer Material circle. Make sure the logodesign on your hat is patch sized Simply take a patch and hold it over the logo.

Remove larger paper back it overlaps on the edges. After its in place use a few pieces of painters tape to hold it in place. Place firmly on the custom hat and hold for 30 seconds or more.

Press gently but firmly all around on your fabric to smooth in place. If the material shifts too easily you may want to use a light spray of embroidery-specific adhesive to secure it. Without a commercial plotter or laser you can still cut material by hand in.